FLOW 2 Lock Installation Guide

By LONO WEAR

FLOW 2 — Lock In Installation Guide
FLOW 2

Lock In — Installation Guide

7 quick steps to get laced up
Once you're locked in, there's no looking back.
01
Unbox & Lay Out

Unbox & Lay Out

Lay out the lock cable, 2 connector brackets, 2 cable end caps, and 2 cap clips.

02
Thread the Cable

Thread the Cable

Feed the lock cable through each eyelet, keeping tension even.

03
Trim to Length

Trim to Length

Try the shoe on, then cut the lock cable to length.

Tip: leave 2cm more than your desired length.

04
Lightly Burn the Ends

Lightly Burn the Ends

Carefully melt the raw cable ends with a flame to seal them and stop fraying.

05
Tape the Cable Ends

Tape the Cable Ends

Tape the cable ends before capping.

06
Attach Cap & Bracket

Attach Cap & Bracket

Fit the cable end cap and cap clip, then press the connector bracket into place.

07
Final Result

Final Result

Test fit, adjust tension, repeat for the second shoe.

You're Locked In
Enjoy your FLOW 2 fit.
FLOW 2 — LOCK IN

Reading next

A Healthier Alternative to Traditional Shoes - LONOWEAR

A Healthier Alternative to Traditional Shoes

Dec 8, 2024
LONO WEAR

Leave a comment

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

Retail Locations

Select each drop down to see detailed retail addresses.

____________

Business address (not a retail location):
Lonowear Limited Unit A69, LG/F, Valiant Industrial Centre, 2-8 Au Pui Wan Street, Fo Tan, Sha Tin, Hong Kong